Gigabyte Tv dvb-t card na ubuntu 8.04

[velimir]

TEško mi je dalje išta reći. Pokušat ću doma gdje imam TV karticu u jenoj mašini, pa ćemo dalje istraživati. OK?

Ok,ali i dalje ti nudim da preko remote desktopa procesljas po mome kompu ako ti se da.

[Grof]

Hoću, ali od doma, gdje nemam firewall. Nego ti znaš poštelati svoj router preko DynDNS-a i napraviti port forwarding za VNC, kako bi mu ja mogao pristupiti?

[velimir]

Hoću, ali od doma, gdje nemam firewall. Nego ti znaš poštelati svoj router preko DynDNS-a i napraviti port forwarding za VNC, kako bi mu ja mogao pristupiti?

Budem samo reci sto tocno trebas da dodam jer imam thomsonov router pa sam dodam rule i port range u njemu.

[Grof]

Hoću, ali od doma, gdje nemam firewall. Nego ti znaš poštelati svoj router preko DynDNS-a i napraviti port forwarding za VNC, kako bi mu ja mogao pristupiti?

Budem samo reci sto tocno trebas da dodam jer imam thomsonov router pa sam dodam rule i port range u njemu.

OK, reći ću ti negdje navečer od doma u poruku, ne znam broj porta na pamet. A DynDNS si sredio?

[velimir]

OK, reći ću ti negdje navečer od doma u poruku, ne znam broj porta na pamet. A DynDNS si sredio?[/quote]

NIsam ali nije problem.

[Grof]

OK, reći ću ti negdje navečer od doma u poruku, ne znam broj porta na pamet. A DynDNS si sredio?

NIsam ali nije problem.[/quote]

OK, trebaš napraviti port forwarding za port: 5900, te preko DynDNS-a podesiti ime tvoje dinamičke IP adrese.

[velimir]

To o cemu govoris ja nemam pod postavkama,mogu ti jedino postavit VPN,HTTP server ili tak nesto slicno u routeru i stavit default port 5900 a dynDNS nema.Radi se o thomsonovom speedtouch ST780i modelu routera pa vidi da li mogu jos sto napravit.Zar nema neki program poput logmein ili teamwivier za linux?

[velimir]

Evo Grofe nasao sam u cemu je problem,kartica je detektirana kao saa7133 a ne kao 7134 chipset a evo ti sto kaze dmesg


[ 35.175781] saa7133[0]: found at 0000:07:00.0, rev: 209, irq: 21, latency: 32, mmio: 0x92010000
[ 35.175790] saa7133[0]: subsystem: 1458:9002, board: UNKNOWN/GENERIC [card=0,autodetected]
[ 35.175808] saa7133[0]: board init: gpio is c040000
[ 35.310299] saa7133[0]: i2c eeprom 00: 58 14 02 90 54 20 1c 00 43 43 a9 1c 55 d2 b2 92
[ 35.310311] saa7133[0]: i2c eeprom 10: ff ff ff 0f ff 20 ff ff ff ff ff ff ff ff ff ff
[ 35.310321] saa7133[0]: i2c eeprom 20: 01 40 01 02 02 01 01 03 08 ff 00 c1 ff ff ff ff
[ 35.310330] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 35.310340] saa7133[0]: i2c eeprom 40: ff 21 00 c2 96 10 03 32 15 50 ff ff ff ff ff ff
[ 35.310349] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 35.310359] saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 35.310368] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 35.310566] saa7133[0]: dsp access error
[ 35.310570] saa7133[0]: dsp access error
[ 35.310575] saa7133[0]: dsp access error
[ 35.310615] saa7133[0]: registered device video0 [v4l2]
[ 35.310640] saa7133[0]: registered device vbi0
[ 35.310646] saa7133[0]: dsp access error
[ 35.310648] saa7133[0]: dsp access error
[ 35.310918] ACPI: PCI Interrupt 0000:07:01.0[A] -> GSI 22 (level, low) -> IRQ 23
[ 35.891171] saa7134 ALSA driver for DMA sound loaded
[ 35.891206] saa7133[0]/alsa: saa7133[0] at 0x92010000 irq 21 registered as card -2
[ 35.908310] ath_rate_sample: 1.2 (0.9.4)
[ 35.908865] wifi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
[ 35.908872] wifi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
[ 35.908883] wifi0: turboG rates: 6Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
[ 35.908890] wifi0: H/W encryption support: WEP AES AES_CCM TKIP
[ 35.908894] wifi0: mac 7.9 phy 4.5 radio 5.6
[ 35.908899] wifi0: Use hw queue 1 for WME_AC_BE traffic
[ 35.908901] wifi0: Use hw queue 0 for WME_AC_BK traffic
[ 35.908903] wifi0: Use hw queue 2 for WME_AC_VI traffic
[ 35.908905] wifi0: Use hw queue 3 for WME_AC_VO traffic
[ 35.908907] wifi0: Use hw queue 8 for CAB traffic
[ 35.908908] wifi0: Use hw queue 9 for beacons
[ 35.919397] wifi0: Atheros 5212: mem=0x92000000, irq=23
[ 35.924393] input: ImExPS/2 Logitech Explorer Mouse as /devices/platform/i8042/serio1/input/input5
[ 36.844104] lp0: using parport0 (interrupt-driven).
[ 36.895329] Adding 3229024k swap on /dev/sda5. Priority:-1 extents:1 across:3229024k
[ 37.447188] EXT3 FS on sda1, internal journal
[ 38.573406] ip_tables: (C) 2000-2006 Netfilter Core Team
[ 38.967686] No dock devices found.
[ 39.995879] apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16ac)
[ 39.995887] apm: disabled - APM is not SMP safe.
[ 40.115905] ppdev: user-space parallel port driver
[ 40.213334] audit(1212858680.453:2): type=1503 operation="inode_permission" requested_mask="a::" denied_mask="a::" name="/dev/tty" pid=5078 profile="/usr/sbin/cupsd" namespace="default"
[ 40.909629] saa7133[0]: dsp access error
[ 40.909636] saa7133[0]: dsp access error
[ 40.917711] saa7133[0]: dsp access error
[ 40.917718] saa7133[0]: dsp access error
[ 41.148760] e1000: eth0: e1000_watchdog: NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX
[ 41.148770] e1000: eth0: e1000_watchdog: 10/100 speed: disabling TSO
[ 41.195132] Bluetooth: Core ver 2.11
[ 41.195514] NET: Registered protocol family 31
[ 41.195519] Bluetooth: HCI device and connection manager initialized
[ 41.195525] Bluetooth: HCI socket layer initialized
[ 41.210926] Bluetooth: L2CAP ver 2.9
[ 41.210932] Bluetooth: L2CAP socket layer initialized
[ 41.260698] Bluetooth: RFCOMM socket layer initialized
[ 41.260715] Bluetooth: RFCOMM TTY layer initialized
[ 41.260718] Bluetooth: RFCOMM ver 1.8
[ 45.351523] NET: Registered protocol family 17
[ 46.883720] NET: Registered protocol family 10
[ 46.884133] lo: Disabled Privacy Extensions
[ 54.997704] saa7133[0]: dsp access error
[ 54.997712] saa7133[0]: dsp access error
[ 56.153637] saa7133[0]: dsp access error
[ 56.153644] saa7133[0]: dsp access error
[ 57.060256] eth0: no IPv6 routers present
[ 57.104197] ath0: no IPv6 routers present
[ 346.713612] saa7133[0]: dsp access error
[ 346.713622] saa7133[0]: dsp access error
[ 346.713654] saa7133[0]: dsp access error
[ 346.713657] saa7133[0]: dsp access error
[ 346.713673] saa7133[0]: dsp access error
[ 346.713677] saa7133[0]: dsp access error
[ 346.716572] saa7133[0]: dsp access error
[ 346.716582] saa7133[0]: dsp access error
[ 346.782967] saa7133[0]: dsp access error
[ 346.782975] saa7133[0]: dsp access error
[ 346.782999] saa7133[0]: dsp access error
[ 346.783008] saa7133[0]: dsp access error
[ 346.970478] saa7133[0]: dsp access error
[ 346.970487] saa7133[0]: dsp access error
[ 371.507430] saa7133[0]: dsp access error
[ 371.507438] saa7133[0]: dsp access error
[ 440.595564] saa7133[0]: dsp access error
[ 440.595572] saa7133[0]: dsp access error
[ 440.595598] saa7133[0]: dsp access error
[ 440.595601] saa7133[0]: dsp access error
[ 440.595615] saa7133[0]: dsp access error
[ 440.595617] saa7133[0]: dsp access error
[ 440.669572] saa7133[0]: dsp access error
[ 440.669579] saa7133[0]: dsp access error
[ 440.669603] saa7133[0]: dsp access error
[ 440.669613] saa7133[0]: dsp access error
[ 440.855650] saa7133[0]: dsp access error
[ 440.855660] saa7133[0]: dsp access error
[ 458.992291] saa7133[0]: dsp access error
[ 458.992302] saa7133[0]: dsp access error
ivica@ivica-desktop:~$

[velimir]

A evo i linka u kojem je objasnjeno u cemu je problem http://tvtime.sourceforge.net/problems.html#undetected

[velimir]

I nije saa7134 nego saa7131e chipset dakle krivo je ucitan modul.